Surge protection should be used for all outdoor installations.



The low cost, high performance, and small form factor of NanoStationM and NanoStationlocoM make them extremely versatile and economical to deploy. NSM5





* The Main port is labeled LAN on the NanoStationlocoM2/M5.The LED will light green when the device is connected to a power source.The LED will light steady green when an active Ethernet connection is made to the Main/LAN port and flash when there is activity.

The NanoStation ® M can be deployed for Point-to-Point (PtP) bridging, wireless connectivity to a video surveillance system, or use as an airMAX ® CPE.

(NanoStation M2/M3/M5 only) The LED will light steady green when an active Ethernet connection is made to the Secondary port and flash when there is activity.In airOS®, you can modify the threshold values for the wireless signal strength LEDs on the Advanced tab under Signal LED Thresholds. Models:

locoM9,



NSM365




NSM2








OUR EULA WAS UPDATED ON AUGUST 7, 2020. locoM2,

The NanoStationM and NanoStationlocoM take the same concept to the future with sleek and elegant form factors, along with integrated airMAX® (MIMO TDMA protocol) technology.

Deze kan immers zowel voor binnen of buiten worden gebruikt.

The default values are shown below:(NanoStationM2/M3/M5 only) This 10/100 Ethernet port is used for bridging and supports software-configurable PoE passthrough.This 10/100 Ethernet port is used to connect the power and should be connected to the LAN and DHCP server.To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the device is powered on. NSM365,

Setup using the UNMSDevices must be professionally installed and it is the professional installer’s responsibility to make sure the device is operated within local country regulatory requirements.The Antenna Gain and Output Power fields are provided to the professional installer to assist in meeting regulatory requirements.





The default values are shown below:This 10/100 Ethernet port is used to connect the power and should be connected to the LAN and DHCP server.To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the device is powered on.

Dit instapmodel werkt op de 2,4 GHz band en heeft een zendvermogen van 23dBm.